You are Here:
Kahles 624i issues

Author (Read 56 times)

Kahles 624i issues
« on: August 04, 2018, 11:38:02 AM »
 

dcaven

  • Target Painter
  • *
  • 1
    Posts
  • Karma: 0
  • FNG
Sighted scope in and reset zero stop. Took a lot of elevation adjustment to sight in.   Rifle is now zeroed at one full turret revolution rather than at absolute zero. Scope is on a 20 moa base plate but still am midway through scope range at zero. Suggestions?
 

Re: Kahles 624i issues
« Reply #1 on: September 12, 2018, 04:01:01 PM »
 

Pvt.Donut

  • Target Painter
  • *
  • 26
    Posts
  • Karma: 0
  • FNG
Did you install the 20 MOA on correctly? Maybe you installed it backwards and it's sloping the wrong way?

I think Kahles notes the Elevation adjustment range at 25.5 MIL. I believe they mean from center so 51 MIL total. You said you needed one full rotation, I'm assuming UP, from center to zero. So that gives you 15.5 MIL from zero to max elevation. Plus the 20 MOA base (6 MIL) give you back that 6 MIL. Now you're sitting at 21.5 MIL which is pretty standard and should get you out to 1,000-1,400 yards while still having a 100 yard zero.